BEL Harness

BEL Harness Swap Boards

Currently we do not offer a direct BEL connector swap board. We have a solution for you though! We can provide the correct style connectors to mate with our current swap board design. You will be required to de-pin some of your BEL connectors and re-pin them to the appropriate APB style connector.

The two APB style connectors, Red and White, can be provided by 27swap, the orange connector will need some pins switched, and black and brown connectors remain unchanged!

Connector

Black: no changes

Brown: no changes


Orange:

  1. Remove pin 1 (red/green) from connector. Cut the pin off the end of the wire. This will be used later

  2. Remove pin 5 (black/blue) from connector, insert this into position 1

  3. Remove pin 4 (black/blue) from connector, insert this into position 5


White:

  1. Remove each pin (1-13) starting with position 1. Insert each pin into the corresponding position on the white APB connector

  2. Remove pin 16 (red/grey), cut the pin off the end of the wire and connect to an inline 20A fuse. On the other side of the 20A fuse connect the wire from pin 1 (red/green) from the orange connector.


Red

  1. Pin 13 (orange/brown) moves to position 14 on the red APB connector

  2. Pin 14 (orange/black) moves to position 15 on the red APB connector

  3. Pin 15 (blue/red) moves to position 1 on the 3 pin red APB connector

  4. Pin 16 (purple/blue) moves to position 2 on the 3 pin red APB connector