BNS to BEL

Preparation and Mounting

To begin installation, ECU cover should be removed. Drivers side kick panel should also be removed. Route ArduAudi pigtails through the interior into the ECU chamber. ArduAudi will fit between the fuse box and metal knee bracket or directly above the fuse box. Final mounting is up to the individual. Ensure ArduAudi is secure.

*DO NOT connect T17d/7 or T17j/8 to switched power

Wiring

Connectors

T17d - Red connector, Body Harness
T17e - White Connector, Body Harness
T17j - Brown Connector, Body Harness
T17i - White connector, Engine Harness

Connections

Format: Car Connection - ArduAudi Wire Color

T17d/7 (Red/White) - Red
T17j/8 (Red/Yellow) - Yellow
T17e/13 (Orange/Brown) - Orange
T17e/14 (Orange/Black) - Black
T17i/7 (Red/Grey) - Blue
T17i/8 (Blue) - Purple
T17i/9 (Red/Yellow) - Green
T17e/7 (Blue/Green) to T17i/10 (Black/White) - Cruise On/Off
Ignition Switched Power Source - White
Chassis Ground - Brown

Testing and Troubleshooting

Fan Control

With all connections made disconnect ArduAudi chassis ground brown wire. Switch ignition to on and ensure fans turn on high after approximately 2-8 seconds. Reconnect ArduAudi chassis ground wire. Switch ignition to on and the fans should remain off (unless the car is warm and coolant temp is high in which case the fans may come on low/medium/high for a few minutes).

Cruise Control

Switch ignition to on and monitor channel 66 on the ecu via VAG-Com. Cycle the cruise stalk, on/off/set/retard/cancel/resume and take note of the changing values. Ensure your ecu is seeing speed/brake/clutch signals via channel 66. Reference this ross-tech link for more info.

Further Assistance

Contact info@27swap.com

Google Sites

Report abuse